TM 9-2330-211-14&P
4-17. GROUND WIRE REPAIR (Con't)
ACTION
ITEM
REMARKS
LOCATION
Defective contact
a. Using pliers, pull contact pin (12) out of bushing
Bushing (14)
5.
pin (12)
(14).
b. Using soldering tool, heat solder well (11) and
remove from ground wire (6). Discard contact pin
(12).
c. Measure length of ground wire (6) removed and
cut new wire to match using cutting pliers.
Replacement
Using wire stripper, strip insulation from both
6.
ground wire (6)
ends of replacement ground wire (6) equal to depth of
solder well (11) and ring terminal (5) to be installed.
Replacement
Replacement
a. Place solder well (11) onto end of replacement
7.
contact pin (12)
ground wire (6) and solder using soldering tool.
ground wire (6)
b. Push solder well (11) into bushing (14) until
seated.
Bushing (14)
Push bushing (14) into receptacle connector (13).
Receptacle
8.
Ensure that notch (10) is alined with
connector (13)
receptacle connector (13).
Nut (15)
Screw nut (15) onto receptacle connector (13).
9.
10.
Replacement
Ring terminal (5)
a. Slide onto end of replacement ground wire (6).
b. Crimp at wire end using crimping tool.
Front of
11.
Cover (16) and
Push wiring harness (1) back into center hole
receptacle
(7) and aline screw holes (17).
semitrailer
Ensure that notch (8) is at top.
assembly (18)
12.
Four screws (9),
Cover (16) and
Screw in and tighten using wrench, socket
receptacle
replacement ground
and handle.
wire (6), Iockwashers
assembly (18) to
screw holes (17)
(3), and nuts (2)
FOLLOW-ON MAINTENANCE:
Check operation of lights.
TASK ENDS HERE
4-45