TM 9-2330-213-14&P
5-1. REAR AXLE REPLACEMENT (Con't).
3.
Loosen two nuts (5) and remove handbrake cable (3) from guide bracket (11) on backing plate (10).
NOTE
A suitable container should be used to catch any draining brake fluid. Ensure that all
spills are cleaned up.
4.
Loosen nut (7) and disconnect tube (6) from connector (9).
Remove 12 nuts (14), Iockwashers (13), flatwashers (12), screws (8), and backing plate (10) from axle
5.
(4). Discard Iockwashers.
6.
Repeat steps 2 through 5 on opposite end of axle (4).
7.
Remove nut (18), Iockwasher (17), connector (16), and two tubes (6) from axle (4). Discard Iockwasher.
TA505357
5-2