TM 9-2330-213-14&P
5 - 1 . REAR AXLE REPLACEMENT (Con't).
8.
Using floor jack, raise and support axle (4) at
both ends. Remove eight nuts (20), four
U-bolts (22), and two plates (19) from axle (4)
and springs (21).
9.
Carefully lower and remove axle (4) from
springs (21).
b. INSTALLATION
WARNING
Axle (4) is heavy and awkward to handle. Use caution, provide adequate support, and
use assistance during installation. Failure to follow this warning may result in serious
injury.
1.
Carefully raise and position axle (4) on springs (21). Support axle at both ends.
2.
install four U-bolts (22), two plates (19), and eight nuts (20) on axle (4) and springs (21).
Install connector (20) and two tubes (6) on axle (4) with new lockwasher (21 ) and nut (22). Secure tubes
3.
under clips (15).
4.
Install backing plate (10) on axle (4) with 12 screws (8), flatwashers (12), new Iockwashers (13), and
nuts (14).
5.
Connect tube (6) to connector (9) and tighten nut (7).
6.
Position handbrake cable (3) under guide bracket (11) and tighten two nuts (5).
TA505358
5-3