TM 9-2330-227-14&P
TIRE AND WHEEL ASSEMBLY - CONTINUED
ACTION
ITEM
LOCATION
REMARKS
INSTALLATION - CONTINUED
NOTE
Lugbolts (7) are marked R. or L. in direction of forward wheel rotation. To tighten stud
nuts (6) on right side, turn clockwise. To tighten stud nuts (6) on left side, turn
counterclockwise.
9.
Six stud nuts (6)
Screw onto Iugbolts (7), and tighten in
the sequence shown using stud nut wrench.
Axle (4)
10.
Side of frame (3)
a.
Take trestles out from under spring
where tire and wheel
brackets (5.1).
b.
assembly is being
Lower jack until inner tire and wheel
removed
assembly (5) rests on the ground.
a.
Using stud nut wrench, tighten as much
Six stud nuts (6)
11.
Lugbolts (7)
as possible in sequence shown below.
b.
Tighten stud nuts to 400-425 ft-lb
Axle (4)
Raise jack until inner tire and wheel
12.
assembly (5) is off of ground.
4-148.3
Change 1