HUB AND DRUM - CONTINUED
ACTION
ITEM
REMARKS
LOCATION
INSTALLATION - CONTINUED
NOTE
Check adjustment by grabbing drum and attempting to rock it on spindle. If bearings
are properly adjusted, there will be no movement of brakedrum. Brakedrum should not
rock while turning freely.
Slide in place.
Lockwasher (17)
Spindle (6)
31.
and nut (16)
Nut (18)
a.
Screw in, and tighten using hub-nut
Spindle (6) and
32.
wrench.
Iockwasher (17)
b. Using ball-peen hammer and 5/32-inch
drive-pin punch, bend tabs of lock-
washer (17) over nut (16) and nut (18).
a. Put together.
Cap (19) and
Hub (8)
33.
b. Put in place on hub (8).
gasket (20)
Screw in, and tighten using 1/2-inch
Six Iockwashers (21)
Cap (19) and
34.
and nuts (22)
socket and ratchet handle with 1/2-inch
hub (8)
drive.
4-147
