TM 9-2330-227-14&P
DECK - CONTINUED
ACTION
REMARKS
ITEM
LOCATION
REPAIR - CONTINUED
Using number two cross-tip screwdriver,
Screws (2)
1. Molding (1) at
unscrew and take out.
wall nearest board
to be replaced
Take off.
Molding (1)
2. S i d e w a l l
NOTE
Molding will have to be removed from front wall when replacing a short board. Molding
on either side of rear doors will be removed when replacing a long board.
Remove threshold plates or striker plates only as required to replace a damaged board.
Using number two cross-tip screwdriver,
Screws (4)
Molding (3)
unscrew and take out.
Take off.
Molding (3)
Rear wall
Four screws (6)
Using 3/16-inch flat-tip screwdriver,
Threshold
1/2-inch socket, and ratchet handle with
and nuts (7)
plate (5)
1/2-inch drive, unscrew and take out.
Using pry bar, take off.
Threshold
Deck at
plate (5)
rear doors
Four screws (9)
a. Using 3/16-inch flat-tip screwdriver,
Striker
unscrew screws (9) and take out.
and four
plates (8)
b. Using number two cross-tip screw-
screws (10)
driver, unscrew screws (10) and
take out.
Note location of two screw types.
Using pry bar, pry out.
Striker
Deck at
Note positioning of plates.
plates (8)
rear doors
Using 3/16-inch flat-tip screwdriver,
Three screws (12)
Threshold
1/2-inch socket, and ratchet handle with
plate (11)
and nuts (13)
1/2-inch drive, unscrew and take out.
Using pry bar, pry off.
Threshold
Deck at
plate(11)
side door
Two screws (15)
a. Using 3/16-inch flat-tip screwdriver,
Striker
unscrew screws (15) and take out.
and two
plate (14)
screws (16)
