TM 9-2330-235-14&P
4-21.
HANDBRAKE CABLE MAINTENANCE (M390C) (Con't).
b.
INSTALLATION
WARNING
If trailer Is not coupled to towing vehicle, ensure that wheels are securely choked. Failure to do so
may cause trailer to roll, resulting in injury to personnel or damage to equipment.
1. Install nut (2) and clevis (12) on rod (3). Tighten nut against clevis.
2. Install nut (4) on rod (3). Install nut (6) on push-pull control assembly (7).
3. Connect rod (3) and push-pull control assembly (7) with turnbuckle (5).
4. Secure push-pull control assembly (7) to frame with bracket (8), two new lockwashers (9), and screws (10).
5. Thread ball end of push-pull control assembly (7) through hole in backing plate (19) and connect to low end of
lever (20).
6. Secure push-pull control assembly (7) to back side of backing plate (19) with cable guide bracket (16), two new
lockwashers (18), and nuts (17).
7. Install hub and brakedrum (para 4-41).
8. Install wheel (para 4-39).
9. Connect clevis (12) to handbrake lever (14) with straight pin (11) and new cotter pin (13).
10. Perform ADJUSTMENT (subpara c).
TA704314
4-43
