TM 9-2330-235-14&P
4-48.
RETRACTABLE SUPPORT ASSEMBLY MAINTENANCE (M514) (Con't).
5 Install spacer (10) and spindle (11) on support (7) with new spring pin (8).
6. Press two bearing cups (13 and 15) into wheel (14) until firmly and squarely seated.
7. Install Inner bearing (12) in wheel (14) with large diameter facing outside of wheel.
8. Install outer bearing (16) in wheel (14) with large diameter facing outside of wheel.
9. Install wheel (14) and flatwasher (17) on spindle (11).
10. Install nut (18/ on spindle (11. Do not fully tighten nut.
e.
INSTALLATION
Install retractable support assembly on frame with four screws (27), flatwashers (26), new lockwashers (25), and nuts (24).
f.
ADJUSTMENTI
1. Rotate wheel (14) by hand and tighten nut (18) until a distinct drag is felt in wheel. Loosen nut until wheel turns
freely.
2. Secure nut (18) to spindle (11) with new cotter pin (20).
3. Pack cap (19) with grease and install on wheel (14).
TA704339
4-112
