TM 9-2330-246-14
4-14. INTERVEHICULAR CABLE RECEPTACLE REPLACEMENT (Con't).
Remove rubber bushing (4) from receptacle (3). Slide rubber bushing back over wires (2) to expose solder
5.
connections.
6.
Unsolder wires (2) from terminals (5).
b.
CLEANING AND INSPECTION
WARNING
Dry cleaning solvent, P-D-680, is toxic and flammable. Always wear protective goggles
and gloves, and use only in a well-ventilated area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO NOT use near open flame or excessive heat.
The solvent's flash point is 100F-138F (38C-59C). If you become dizzy while
using cleaning solvent, immediately get fresh air and medical help. If solvent contacts
eyes, immediately wash your eyes and get medical aid.
Clean all parts with dry cleaning solvent. Dry thoroughly.
1.
2.
Inspect parts for cracks, breaks, or other damage.
Replace defective parts.
3.
INSTALLATION
c.
1.
Slide nut (1) and receptacle (3) over wires (2).
2.
Push wires (2) through rubber bushing (4).
3.
Solder wires (2) to terminals (5).
4.
Pull wires (2) and terminals (5) into rubber bushing (4).
TA700156
4-20