TM 9-2330-246-14
4-70. WHEEL REPLACEMENT (Con't).
INSTALLATION
b.
NOTE
Hub studs and wheel nuts are marked R on right wheel and L on left wheel.
1.
Position inner wheel (4) on wheel studs (5), convex side facing out. Install six capnuts (3) on wheel studs. Torque
capnuts, using tightening sequence shown, to 450-500 Ib.-ft, (610-678 Nm).
NOTE
Ensure that outer and Inner wheel valve stems are 180 apart and Inner valve stem Is
accessible through outer rim.
2.
Position outer wheel (2) on six studs (5), convex side facing in, Install
SIX wheel
nuts (1) on studs. Lower floor
jack and remove.
Torque sIX wheel nuts (1), using tightening sequence shown, to 450-500 Ib.-ft, (610-678 Nm).
3.
TIGHTENING SEQUENCE
TA700272
4-172