TM 9-2330-246-14
4-107. SIGNAL ENTRY BOX AND POWER ENTRY BOX REPLACEMENT (M348A2K AND
M348A2N) (Con't).
5.
Use adhesive (Item 4, Appendix E) to install new top and bottom gaskets (24) and two new side gaskets (36) on
cover (18).
Install flatwasher (17), latch (16), bushing (1 5), spring washer (1 4), flatwasher (1 3), and new locknut (12) on each
6.
stud on cover (18).
--
Install hinge (6) on cover (18) using nine new rivets (8).
7.
Install each keeper (2) on frame (1) using two new locknuts (4) and flatwashers (3).
8.
Install flatwashers (19), nuts (20), rods (21), and wingnuts (22) on studs in frame (l).
9.
Install hinge (6) with cover attached and spacer (5) on frame (1) using nine new rivets (7).
10.
NOTE
Signal entry box frame is mounted with 18 rivets. Power entry box frame is mounted
with 40 rivets.
Apply adhesive (Item 2, Appendix E) around flange on frame (l). Install frame on semitrailer using new rivets
11.
(23).
Install shield (11) and plate (10) on semitrailer using nine screws (9).
12.
FOLLOW-ON TASKS:
Z Install incoming signal and power cables.
TA700338
4-259