TM 9-2330-246-14
4-116. IDENTIFICATION PLATES AND DECALS REPLACEMENT.
This Task Covers:
b.
Installation
a.
Removal
Initial Setup:
Materials/Parts:
Tools/Test Equipment:
Dry cleaning solvent (Item 13, Appendix E)
General mechanic's tool kit
REMOVAL
a.
1.
Remove identification and instruction plates (1) by removing screws (2).
2.
Remove decals by scraping off.
b.
INSTALLATION
1.
Install identification and instruction plates (1) using screws (2).
WARNING
Dry cleaning solvent, P-D-680, Is toxic and flammable. Always wear protective goggles
and gloves, and use only In a well-ventilated area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO NOT use near open flame or excessive heat.
The solvent's flash point is 10OF-138F (38C-59C). If you become dizzy while
using cleaning solvent, immediately get fresh air and medical help. If solvent contacts
eyes, Immediately wash your eyes and get medical aid.
2.
Clean surface where decal mounts with dry cleaning solvent and dry thoroughly, Apply decal to surface.
TA700348
4-275
