4-113. EXTERIOR BODY REPAIR.
This Task Covers:
b.
Repair
Inspection
a.
Initial Setup:
References:
Z TM 43-0139
INSPECTION
a.
Inspect walls and top panels for dents, creases, and wrinkled metal.
1.
Inspect top, bottom, and corner body moldings for dents, creases, and bends.
2.
Check rivets, screws, nuts, and welds at the walls, top panels, and body molding for presence, tightness, and
3.
separation.
1.
Minor dents, creases, and wrinkles that do not produce holes or metal splinters maybe repaired by sanding
damaged area to remove damaged paint and sharp edges, Repaint after sanding (TM 43-0139).
Damage that results in holes and metal splinters will be repaired by support maintenance.
2.
Damage that is large enough to suspect that inside metal wall parts maybe damaged will be evaluated by
3.
support maintenance.
4-272