TM 9-2330-247-14&P
4-27.
INTERVEHICULAR CABLE (Con't)
ACTION
LOCATION
ITEM
REMARKS
7.
Clamp (16)
Two screws (3),
Using no. 2 cross-tip screwdriver and
in. open-
nuts (14), and
end wrench, unscrew and take off.
Iockwashers (15)
Ground wire (18) will come free.
lntervehicular
T a k e off.
Clamp (16)
8.
cable (5)
REPAIR
NOTE
Repair is limited to connector repair (para 4-26) and ground
wire repair (step 9).
9.
Ground terminal
Ground wire
a. Using stripper, cut off ground terminal (17) and
(18)
(17)
strip ground wire (18) in. (6.35 mm).
b. Place new ground terminal (17) on ground wire
(18) end and crimp using crimping tool.
INSTALLATION
10.
Intervehicular
12 connectors
Put together and push into clips (1).
cable leads (19)
(20)
and chassis wiring
harness leads (21)
11.
Intervehicular
Put on intervehicular cable (5) and aline with screw
Clamp (16)
holes in frame (2).
cable (5)
12.
a. Put screws (3) through screw holes in frame
Two screws (3),
Clamp (16) and
(2) and clamp (16).
frame (2)
Iockwashers (15),
b. Put ground terminal (17) on bottom screw.
nuts (14), and
c. Put lockwashers (15) and nuts (14) on screws (3).
ground wire (18)
d. Tighten using no. 2 cross-tip screwdriver and
in. open-end wrench.
13.
Intervehicular
Put on intervehicular cable (5) and aline with screw
Clamp (6)
holes in frame (2).
cable (5)
a. Put screws (4) through screw holes in frame
14.
Two screws (4),
Clamp (6)
(2) and clamp (6).
Iockwashers (7),
b. Put lockwashers (7) and nuts (8) on screws (4).
and nuts (8)
c. Tighten using no. 2 cross-tip screwdriver and
in. open-end wrench.
Put on and squeeze closed using crimping tool.
Intervehicular
Clamp (11)
15.
cable (5)
a. Put screw (12) through end of clamp (11) and
16.
Clamp (11)
Screw (12),
frame (2) and hook spring (13) on screw.
Iockwasher (10),
b. Put Iockwasher (10) and nut (9) on screw (12).
nut (9), and
c. Tighten using no. 2 cross-tip screwdriver and
spring (13)
in. open-end wrench.
4-37
