TM 9-2330-251-14&P
3-7. WHEEL REPLACEMENT.
a. Removal.
(1) Apply handbrake lever.
(2) Loosen, but do not remove, 5 nuts (3).
(3) Position floor jack under axle (1) near wheel (2) to be removed. Raise axle until wheel is off
ground.
( 4 ) Remove 5 nuts (3).
(5) Remove wheel (2) from wheel hub (4).
b. Installation,
(1) Position wheel (2) on wheel hub (4).
(2) Install and tighten 5 nuts (3) finger
tight.
(3) Lower axle (1) until wheel (2) is on
ground. Remove floor jack.
(4) Tighten 5 nuts (3) using tightening
sequence shown, Have organizational maintenance
tighten nuts to 85 Ib. -ft. (115 Nm) in same se-
quence.
TA503896
3-10
