TM 9-2330-251-14&P
F-3. EXPLANATION OF COLUMNS (SECTIONS II AND Ill) (Con't).
(7) The usable on code, when applicable. (See paragraph F-5, Special Information)
(8) In the Special Tools List section, the Basis of Issue (BOI) appears as the last line(s) in the entry
for each special tool, special TMDE, and other special support equipment. When density of equipments
supported exceeds density spread indicated in the Basis of Issue, the total authorization is increased
proportionately.
(9) The statement "END OF FIGURE" appears just below the last item description in Column 5 for a
given figure in both Section II and Section Ill.
f. QTY [Column (6)]. The QTY (quantity per figure) column indicates the quantity of the item used in
the breakout shown on the illustration/figure, which is prepared for a functional group, subfunctional group, or
an assembly. A "V" appearing in this column in lieu of a quantity indicates that the quantity is variable and the
quantity may vary from application to application.
F-4. EXPLANATION OF COLUMNS (SECTION IV).
a. National Stock Number (NSN) Index.
(1) STOCK NUMBER Column. This column lists the NSN by National Item Identification Number
( N I I N ) s e q u e n c e . The
NIIN
consists
of
the
last n i n e d i g i t s o f t h e N S N ( i . e . ,
NSN
5305 -01-67 4-1467 ). When using this column to locate an item, ignore the first 4 digits of the NSN. Hower-
NIIN
er, the complete NSN should be used when ordering items by stock number.
(2) FIG. Column. This column lists the number of the figure where the item is identified/located.
The figures are in numerical order in Section II and Section Ill.
(3) ITEM Column. The item number identifies the item associated with the figure listed in the
adjacent FIG. column. This item is also identified by the NSN listed on the same line.
b. Part Number Index. Part numbers in this index are listed by part number in ascending alphanumeric
sequence (i.e., vertical arrangement of letter and number combination which places the first letter or digit of
each group in order A through Z, followed by the numbers 0 through 9 and each following letter or digit in like
order).
(1) CAGEC Column. The Commercial and Government Entity (CAGE) Code (C) is a 5-digit alpha-
numeric code used to identify the manufacturer, distributor, or Government agency, etc., that supplies the
item.
(2) PART NUMBER Column. Indicates the primary number used by the manufacturer (individual,
firm, corporation, or Government activity), which controls the design and characteristics of the item by means
of its engineering drawings, specifications standards and inspection requirements to identify an item or range of
items.
(3) STOCK NUMBER Column. This column lists the NSN for the associated part number and
manufacturer identified in the PART NUMBER and CAGE columns to the left.
(4) FIG. Column. This column lists the number of the figure where the item is identified/located in
Section II and Section Ill.
(5) ITEM Column. The item number is that number assigned to the item as it appears in the figure
referenced in the adjacent figure number column.
F-5. SPECIAL INFORMATION.
a. Usable On Code. The usable on code appears in the lower left corner of the Description column
heading. Usable on codes are shown as " UOC: . . . . . . . . . " in the Description column (justified left) on the first
line applicable item description/nomenclature. Uncoded items are applicable to all models. Identification of the
usable on codes used in this RPSTL are:
F-5
