TM 9-2330-271-14&P
(3) Slide nut over wires and bushing to rear of
4-15.
Intervehicular Cable Receptacle
receptacle and tighten nut.
NOTE
a.
Removal.
Receptacle key must be adjacent to
(1) Remove four nuts, washers and screws
which secure cover and receptacle to chassis frame.
cover hinge.
Remove cover and receptacle.
(7) Aline holes in cover and receptacle with
(2) Remove tape to expose nut and wires.
holes in chassis and secure with four screws, washers
(3) Remove nut from receptacle and slide nut
and nuts, with ground lug secured to chassis by one of
back over harness.
the washers and nuts.
(4) Remove rubber bushing from receptacle
and slide bushing back over wires to expose solder
4-16.
External Power Entry Receptacle, XM822 (fig.
connections.
(5) Unsolder wires at rear of receptacle.
b. Cleaning and Inspection.
a. General. An external power entry receptacle is
(1) Clean all parts with an approved cleaning
located on the exterior of the XM822 semitrailer at the
solvent. Dry thoroughly.
rear, roadside.
(2) Inspect all parts for cracks, breaks or other
(4) Make a continuity check of all circuits
damage.
throughout semitrailer.
(3) Replace defective part.
(5) Wrap exposed wires and nut with tape,
c. Installation.
leaving ground wire (with lug) exposed for later
(1) Solder wires to terminals at rear of
installation (step 7 below).
receptacle in accordance with wiring diagram.
(6) Insert ground wire and receptacle into hole
in front of chassis and place cover assembly over
(2) Slide rubber bushing over wires and solder
receptacle flange with center line of cover hinge 90
connections at rear of receptacle.
degrees from center line of van.
Figure 4-20. External power entry receptacle and time clock.
XM822.
4-30
