TM 9-2330-294-14
the same manner as stationary clearance light (para
4-26. Stationary Clearance Light Assembly Repair
4-25 and 4-26).
a. Disassembly. Remove stationary clearance
4-28. Main Wiring Harness
light assembly by following procedure in paragraph
a. Inspect. Check attaching points for security
(1) Loosen two screws securing door to socket
and condition. Inspect wires for security and for
and wiring assembly and remove door, two nuts and
frayed, cracked, or worn insulation. Inspect ter-
lens.
minals to determine if they are free of corrosion, dirt,
(2) Remove four screws and lock washers
or paint which would interfere with good contact.
securing socket and wiring assembly to bracket and
Clean if corroded or covered with dirt or paint. Refer
remove socket and wiring assembly and gasket from
TB ENG361. Use test equipment to determine of
bracket. Install door and lens on socket and wiring
assembly and secure with two screws removed in (1)
b. Cable Connectors Replacement.
above.
(1) Male cable connector. Strip cable in-
(3) For semitrailer 1 through 200 repeat steps
sulation equal to depth of pin contact shell. Apply
(1) and (2) above and remove blackout light.
insulating compound (MIL-S-8660 or P/N 801362
b. Repair. Clean bracket with dry cleaning
(19203) to cable end, and slip shell over cable. Insert
solvent type II (SD-2). Inspect bracket for cracks,
cable into pin contact shell and crimp. Place "C"
bends or other damage and replace if necessary.
washer over cable at crimped junction and slide shell
Replace defective hardware. Repair marker light in
over "C" washer and pin contact.
(2) Female cable connector. Strip cable in-
sulation approximately 1/8 inch. Apply compound
c. Assembly. Assemble in reverse order of
(MIL-S-8660 or P/N 801362 (19203) to cable end,
disassembly (a above). Install stationary clearance
and slip shell and sleeve over cable. Place cylinder
light assembly by following procedure in paragraph
end of terminal on cable and crimp. Slide shell and
4-25b.
sleeve over terminal.
4-27. Rear Marker Light Assembly Replacement
and Repair
Replace or repair the rear marker light assembly in