TM 9-2330.297-14&P
CHASSIS HARNESS REPAIR
This task covers:
Repair
INITIAL SETUP
Tools
Materials/Parts
Pliers, diagonal cutting
Tape, electrical
Tool kit, electrical connector
Wire, 12-gage
ACTION
LOCATION
ITEM
REMARKS
NOTE
This task can be used to repair front, main, or rear chassis wiring
harnesses.
1. Wire harness
Wire harness (1)
a. Remove 6 inches (15.24 centimeters) of
break
tape from wire harness (1).
b Using pliers, stagger trim wires (2).
c. Using wire stripper, strip ends of
wires (2).
2.
a. Using wire stripper, strip both ends of
jumper wires (3).
b Using crimping tool, crimp one splice
(4) on each end of jumper (3).
c. Using crimping tool, install five jumpers
Check splices for good electrical and
mechanical connection.
d. Using electrical tape, wrap each splice
and wire.
Change 1 4-32