TM 9-2330-357-14&P
2-12. OPERATION OF OUTRIGGERS (Con't).
(7) Hold individual outrigger control switches (9) to lower or raise outriggers (3) as necessary
until leveling device (7) in outrigger control panel door (8) indicates semitrailer is level. Release outrigger
control switches.
(8)
Set power switch (6) to OFF position. Close outrigger control panel door (8).
(9)
Disconnect slave cable from connector (5).
b.
Raising.
NOTE
To manually raise outriggers, only perform steps (7) and (8). To electrically raise
outriggers, skip step (7).
(1)
Connect slave cable to connector (5) on semitrailer.
(2)
Open outrigger control panel door (8). Set power switch (6) to ON position.
CAUTION
DO NOT raise outriggers Individually until semitrailer wheels are on ground.
Raise front outrlggers or rear outriggers together. DO NOT operate left front and right rear or
right front and left rear at same time. Doing so could cause semitrailer to tip over.
(3)
Hold outrigger control switches (9) in pairs to raise outriggers (3) until semitrailer wheels
are on ground.
TA706426
2-19
