TM 9-2330-357-14&P
Section III. MAINTENANCE PROCEDURES
Page
Paragraph Title
Number
Caging and Uncaging Brakes Manually ...................................................................................
Cleaning of Air Couplings .............................................................. .........................................
Cleaning of Electrical Connectors .......................................................... .................................
General ......................................................................... .........................................................
Servicing Air Reservoir ................................................................... ........................................
Wheel and Tire Replacement ........................................... ......................................................
3-6. GENERAL.
The following paragraphs contain those maintenance procedures to be performed by operator/crew. If a
problem with the equipment is discovered that cannot be corrected, notify Organizational Maintenance.
3-7. CLEANING OF ELECTRICAL CONNECTORS.
a. Use a clean rag (Item 14, Appendix E) to remove any buildup of grease, dirt, or dust on electrical
connector (1) and slave cable electrical connector (2).
WARNING
Dry cleaning solvent, P-D-680, is toxic and flammable. Always wear protective goggles and
gloves, and use only in a well-ventilated area. Avoid contact with skin, eyes, and clothes, and
DO NOT breathe vapors. DO NOT use near open flame or excessive heat. The solvent's flash
point Is 100 -138 (380C-590C). If you become dizzy while using cleaning solvent,
F
F
Immediately get fresh air and medical help. If solvent contacts eyes, immediately wash your
eyes and get medical aid.
b. Use a scrub brush (Item 4, Appendix E) and dry cleaning solvent (Item 16, Appendix E) to thoroughly
clean electrical connectors (1 and 2), and allow to dry.
TA706433
3-11
