TM 9-2330-357-14&P
Section II. SERVICE UPON RECEIPT
Page
Paragraph Title
Number
General ............................................................................... .....................................................
Inspection Instructions ............................................................. .................................................
Servicing Instructions .................................................................... ...........................................
4-4. GENERAL.
When a new, used, or reconditioned semitrailer is first received, determine whether it has been properly
prepared for service and is in condition to perform its mission. Follow inspection instructions in paragraph 4-5
and servicing instructions in paragraph 4-6.
4-5. INSPECTION INSTRUCTIONS.
a Refer to DD Form 1397 for procedures on unpacking the semitrailer.
b. Remove all straps, plywood, tape, seals, and wrappings from the semitrailer.
WARNING
Dry cleaning solvent, P-D-680, is toxic and flammable. Always wear protective goggles and
gloves, and use only In a well-ventilated area. Avoid contact with skin, eyes, and clothes, and
DO NOT breathe vapors. DO NOT use near open flame or excessive heat. The solvent's flash
point is 100 -138 (38 -59 ). If you become dizzy while using cleaning solvent, Immediately
F
F
C
C
get fresh air and medical help. If solvent contacts eyes, Immediately wash your eyes and get
medical aid.
c. Remove rust preventive compound from coated exterior parts of semitrailer using dry cleaning
solvent(Item 16, Appendix E) and rags (Item 14, Appendix E).
d. Inspect semitrailer for damage incurred during shipping. Also check to see if the semitrailer has been
modified.
e. Check semitrailer against packing list to ensure that shipment is complete. Report discrepancies or
damage in accordance with instructions in DA Pam 738-750.
4-6. SERVICING INSTRUCTIONS.
a. Perform all operator/crew and organizational PMCS. Schedule next PMCS on DD Form 314.
b. Check bottom of trunnion pivot for grease fitting. If grease fitting is not present, remove plug and install
grease fitting.
c. Torque all wheel lugnuts to 450-500 Ib.-ft. (610-678 Nom)..
d. Lubricate all lubrication points as described in (Lubrication Instructions, Chapter 3, Section I), regardless
of interval.
e. Report any problems discovered during servicing procedures on DA Form 2407.
f. Perform a break-in road test of 25 mi (40 km) at a maximum speed of 55 mph (88 kph).
4-2
