TM 9-2330-357-14&P
APPENDIX G
ILLUSTRATED LIST OF MANUFACTURED ITEMS
Section I. INTRODUCTION
G-1. SCOPE.
a. This appendix includes complete Instructions for making Items authorized to be manufactured or
fabricated.
b. A par t number index In alphanumeric order is provided for cross-referencing the part number of the item
to be manufactured to the figure which covers fabrication criteria.
c. All bulk materiels needed for manufacture of an item are listed by National Stock Number (NSN), part
number, or specification number in the manufacturing instructions. All dimensions given are in standard units.
G-2. GENERAL INSTRUCTIONS.
a. For metal tubing, use a tube cutting tool and cut the tube to the specified length.
b. Bend the tube to the configurations shown. Be careful not to kink the tube.
c. If possible, use the old connectors; if not, replace connectors and install them on the new tube.
d. Flare the ends of the tube using a tube flaring tool.
e. Clean particles out of the tubes before installation.
Table G-1. Manufactured Items Part Number Cross-reference Index.
Figure
Part Number
Figure Title
Number
11670031-1
Branched Wiring Harness
11670216-1
Power Source-to-Relay Wiring Harness
11670253
Branched Wiring Harness Assembly
11686124
Outrigger Control Panel Wiring Harness
11686125
Outrigger Control Panel Cable Assembly
11686242
Outrigger Control Panel Box Wiring Harness Assembly
11686263
Interlock Branched Wiring Harness
11686268
Interlock Lead Assembly
12259667-1
Master Relay Wiring Harness
12296446
Master Relay Lead Harness Assembly
N/A
Horizontal Jig
N/A
Vertical Jig
N/A
Vertical Jig (Alternate)
N/A
Switch Adjustment Tool
G-1
