TM9-2330-358-14&P
CAUTION
Do not twist clearance light to install in frame.
Connectors may become disconnected and light will not
operate.
(3) Snap clearance light (1) into position in frame (4).
(4) Connect electrical power and test for proper operation.
TASK END HERE
4-25.
BAR LAMP ASSEMBLY (M871 ONLY)
This task covers:
Removal
Disassembly
Assembly
Installation
INITIAL SETUP
Tools
General mechanics tool kit
Removal.
a.
WARNING
Disconnect all outside power before performing any
maintenance on the electrical system. Failure to do so
could result in injury.
NOTE
The M871A1 semitrailer does not have a bar lamp
assembly. To remove the three lights on the M871A1
semitrailer, follow the clearance light procedure.
(1) Remove four screws (1, fig. 4-14) and ease bar lamp assembly (2) from rear
of semitrailer (3).
(2) Remove ground strap (4) from screw (l).
(3) Disconnect wiring.
4-36
