TM9-2330-358-14&P
Figure 4-44.
Dock Bumper
(2) Install two screws (3), washers (2) and nuts (l).
(3) Repeat steps (1) and (2) for other bumpers as needed.
TASK ENDS HERE
4-49.
CHOCK BLOCKS
This task covers:
Personnel Required
Removal
Installation
Two
a.
Removal.
WARNING
Wear welding mask, gloves, and apron when welding or
using cutting torch. Failure to wear adequate
protective clothing may result in serious injury.
NOTE
Mark location of chock block chain on frame before
beginning procedure. Measure and record length of new
chain required to properly emplace chock block.
(1) Using cutting torch, cut weldment (fig. 4-45).
4-83
