TM9-2330-372-14&P
Section V. ORGANIZATIONAL MAINTENANCE PROCEDURES
NOTE
Figure numbers cited pertain to Appendix F unless otherwise indicated.
4-12. COMPOSITE LIGHTS (Fig. 1).
a. Removal.
(1) Remove plastic tiedown strap. Tag and disconnect connectors for wiring harness.
(2) Remove two cap screws (12) and lock washers (11). Remove light (1).
b. Repair.
(1) Loosen six captive screws and remove door (2).
NOTE
Do not remove packing (3) unless damaged.
(2) Remove lamps from body.
(3) Install new lamps in body as required by pressing into socket and turning clockwise.
(4) Install new packing (3) if packing was removed and fasten door to body with captive screws.
c. Installation.
(1) Install composite light (1) on trailer with two cap screws (12) and lock washers (11).
(2) Connect connectors to wiring harness. Make sure that tag or marker numbers on wires correspond. Install
plastic tiedown strap.
NOTE
Remove complete harness only if required to effect repair or replacement.
a. Removal.
(1) Remove plastic tiedown straps and remove connectors from strap assembly (10, fig. 2).
(2) Disconnect intervehicular cable connectors from wiring harness connectors at junction.
4-11
