TM9-2330-372-14&P
(3) Remove nine clamps (1, fig. 4) securing harness to frame by removing nine nuts (4) at nine positions
along frame.
(4) Remove harness.
b. Repair.
(1) If any connector terminal is damaged, replace it. Push back shell to expose terminal, remove defective
terminal, and crimp a new terminal on end of wire. Pull shell over terminal.
(2) If individual harness wires extending from the harness loom are broken, cut off defective piece of wire and
splice on new length of wire. Install new terminal and shell to new wire.
(3) Replace deteriorated grommets on frame if harness has been removed.
c. Installation.
NOTE
Do not damage wiring or insulation during installation of wiring harness.
(1) Feed wiring harness through grommets on frame, starting from rear of trailer.
(2) Run wiring harness along frame then through grommets. Install clamps over harness and attach to studs
with nuts in nine places.
(3) Position connectors at both taillight assemblies and reconnect.
(4) Position connectors at intervehicular cable and reconnect.
(5) Install plastic tiedown strap.
(6) Connect trailer to towing vehicle and check operation of all lights.
a. Removal.
(1) Remove plastic tiedown strap and tag and disconnect cable connectors from wiring harness at junction.
(2) Remove two clamps (1 and 5, fig. 4) securing intervehicular cable to trailer frame by removing nut (4) and
screw (6).
(3) Remove intervehicular cable.
b. Cleaning and Inspection.
4-12
