TM 9-2330-373-14 & P
Table 4-2. Troubleshooting (cont)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
BRAKE SYSTEM (cont)
Step 5. Check to see if brake fluid is low in master cylinder.
Fill master cylinder with brake fluid to one-half inch to three-eighths of an inch below top of reservoir.
Step 6. Check for air in hydraulic brake system.
Step 7. Check relay valve for defect.
Perform operating test (para 4-25). Replace relay valve if necessary.
Step 8. Check for leaks in hydraulic system.
Tighten or replace connections.
Step 9. Check to see if brakes are out of adjustment.
Step 10. Inspect for grease or
brake fluid on brake
lining (1).
Replace brake shoe if lining
has grease or brake fluid
replace wheel cylinder, if
TA 314752
4-22