TM 9-2330-373-14 & P
5-6. WIRING HARNESS (cont)
REPLACEMENT OF SINGLE WIRES
1. Remove and discard electrical insulating tape binding wires of defective branch.
2. Cut defective wire from branch, leaving enough wire for splicing.
3. Cut new piece of wire to same length (plus splice) as defective wire and splice to harness. Tape splice with
insulating tape.
4. Assemble new terminals, washers, sleeves and electrical shells to ends of new wire as required. Install marker
band.
5-7. AXLE ASSEMBLY
THIS TASK COVERS
a. General
b. Removal
c. Cleaning
d. Inspection and repair
e. Assembly of new axle
f. Installation
Test Equipment Required:
None
Personnel Required:
2
GENERAL
Generally, axle assemblies will not be removed unless inspection shows a need for repair or replacement.
For inspection purposes, remove wheels (para 3-7) and hubs and brake drums (para 4-30).
REMOVAL
WARNING
Weight of semitrailer must be supported by leveling jacks or by blocking or support
stands placed under rear corners of frame throughout operation.
TA 314855
5-5
