TM 9-2330-376-14&P
4-43. TIRE AND WHEEL REPLACEMENT (Con't).
Place jack between two U-bolts of trunnion axle (4) on side where tire and wheel (3) is being removed. Raise
3.
trunnion axle until tire and wheel is clear of ground.
Remove six nuts (2).
4.
Remove tire and wheel (3) from hub.
5.
INSTALLATION
b.
NOTE
Refer to paragraph 2-14 for spare tire carrier operation.
Position wheel and tire (3) on hub.
1.
Loosely install six nuts (2).
2.
Alternately tighten six nuts (2) in sequence shown until nuts are snug.
3.
4.
Lower trunnion axle (4) and remove jack.
Torque six nuts (2) to 340-350 Ib-ft (454 474
in sequence shown.
5
Remove wheel chocks (1) and stow.
6.
TA700980
PIN: 064498-001
4-80 Change 1
