TM 9-2330-376-14&P
Section Il. MANUFACTURING INSTRUCTIONS
1. Fabricate from part number 10905840, strap, tie-down, electrical.
2. Cut length as required for installation to make part number 10905840-AR.
3. Round edges may be obtained by fusion.
Figure G-1. Tie-down Support Strap.
1. Fabricate from NSN 4010-00-171-4236, part number 7068272, rope, wire.
2. Cut length of 70.00 in. Form a loop of 4.00 in. at one end and install sleeve, part number
MS51844-26. Crimp sleeve. Apply part number 12314081-1 to finished length of 64.00 in.
3. Cut length of 14.00 in. Form a loop of 3.88 in. at one end and install sleeve, part number
MS51844-24. Crimp sleeve. Apply part number 12331704-1 to finished length of 18.38 in.
Figure G-2. Inertia Brake Actuator Wire Ropes.
TA701019
G-2
