TM 9-2330-376-14&P
APPENDIX
H
TORQUE
LIMITS
H-1. SCOPE.
This appendix lists standard torque values, as shown in Table H-1, and provides general information for
applying torque. Special torque values and tightening sequences are indicated in the maintenance procedures for
applicable components.
H-2. GENERAL.
a. Always use the torque values listed in Table H-1 when the maintenance procedure does not give a specific
torque value.
b. Unless otherwise indicated, standard torque tolerance shall be 10%.
c. Torque values listed are based on clean, dry threads. Reduce torque by 10% when engine oil is used as a
lubricant. Reduce torque by 20% if new plated capscrews are used.
d. Capscrews threaded into aluminum may require reductions in torque of 30% or more of Grade 5
capscrews torque. Capscrew threaded into aluminum must also attain two capscrew diameters of thread
engagement.
H-1
