TM 9-2330-381-14
2-27. DUAL WINCH LOADING AND UNLOADING (CONT)
WARNING
Hearing protection must be worn when near winching station or operating winches
or injury to personnel may result.
(4) Raise guard (9) and lock in upright position.
(5) Make sure both DRIVERS SIDE WINCH KICKOUT (20) and PASSENGER SIDE WINCH KICKOUT (21)
switches are ENGAGED (pushed away from operator).
(6) Make sure CABLE HOLD DOWN lever (22) is ON (pushed away from operator).
(7) Pull DRIVERS SIDE WINCH lever (35) upward momentarily until there is enough slack in drivers side winch
cable (36) to be removed from stow hook (25). Move clevis on winch cable (36) off of stow hook (25) to
unstow winch cable. Continue paying out winch cable (36) until spotter on the ground can reach clevis.
Release lever (35).
(8) Pull PASSENGER SIDE WINCH lever (23) upward momentarily until there is enough slack in passenger side
winch cable (24) to be removed from stow hook (25). Move clevis on winch cable (24) off of stow hook to
unstow winch cable. Continue paying out winch cable (24) until spotter on the ground can reach clevis.
Release lever (23).
(9) Remove cotter pin (26) and shouldered pin (27) from clevis on passenger side winch cable (24) and drivers
side winch cable (36).
(10) Remove two large shackles (11) from four load binders (12) and rear payload tiedown rings.
WARNING
Failure to extend safety rail while attaching or removing payload winch cable may
cause injury to personnel.
(11) Unlatch and extend gooseneck safety rail (43).
(12) Install one large shackle (11) each to upper right recovery eye (16) and upper left recovery eye (15).
(13) Pull out passenger aide winch cable (24) and attach clevis to shackle (11) on payload upper right recovery
eye (16). Secure winch cable (24) by installing shouldered pin (27) and cotter pin (26).
(14) Pull out drivers side winch cable (36) and attach clevis to shackle (11) on payload upper left recovery eye
(15). Secure winch cable (36) by installing shouldered pin (27) and cotter pin (26).
2-162.2 Change 1
