TM 9-2330-381-14
2.
Inspect loom for breaks, cracks, and damage. If defective, replace loom portions as required. Use electrical tape
at split end of loom as required.
3.
Inspect for missing or unreadable harness and wire markers (13 and 14). If defective, apply new markings or
replace markers. Use semitrailer electrical schematic (figure FO-1) as a guide for proper wire markings.
INSTALLATION
NOTE
Pull 1 harness out approximately 12 inches (30 cm) past front of gooseneck prior
to securing the cable clamps.
Tiedown straps should be placed in a logical position to secure wiring harness.
1.
Install W1 harness (5) onto gooseneck and platform.
4-141
