TM 9-2330-381-14
4-89. HYDRAULIC FILTER (CONT)
Materials/Parts
Dry cleaning solvent, item 26, appx. E
Preformed packing (2)
Preformed packing
Filter element
Personnel Required:
2
General Safety Instructions
WARNING
Hydraulic fluid may be absorbed through the skin. Avoid prolonged exposure to
skin and wear long sleeves, gloves, and goggles or face shield. If hydraulic fluid
gets into the eyes, flush them immediately with water and seek medical attention.
If hydraulic fluid gets on skin, wash thoroughly with soap and water. Wash hands
thoroughly prior to eating or smoking.
Hydraulic fluid may be hot if system has been in operation. Allow time for system
to cool before performing maintenance or injury to personnel may result.
Residual pressure may remain in hydraulic lines. Open fittings slowly or injury to
personnel may result.
CAUTION
All fittings and openings must be capped or plugged immediately after opening to
prevent dirt, moisture, or foreign material from entering the hydraulic system or
damage to equipment may result.
ELEMENT CHANGE
1.
Make sure hydraulic control module door panel is lowered (para. 2-6).
2.
Using two people, remove six capscrews (1), lockwashers (2), and lower panel (3) from hydraulic control module
(4). Carefully remove lower panel (3), with panel door attached, out from under semitrailer and place on platform.
3.
Using a drain pan and 1-1/4-inch wrench, unscrew and remove filter element housing (5) from filter block (6).
4-436