TM 9-2330-381-14
10.
Remove nut (18), lockwasher (19), washer (20), screw (21), and two cable clamps (22) from cables (23 and 24).
Discard lockwasher.
11.
Remove nut (25) and lockwasher (26) from bolt (27). Tag and remove cables (24 and 28). Remove bolt (27) and
tag and remove wire. Discard lockwasher.
12.
Remove nut (29) and lockwasher (30) from stud #4 of solenoid (31). Tag and remove cable (23) and jumper (32).
Retain lockwasher. Remove and discard grommet (33).
13.
Remove nut (34), lockwasher (35), and capscrew (36) from cable (37) and electrical box (17). Tag and remove
cable (37) and grommet (38). Discard lockwasher and grommet.
INSPECTION
1.
Inspect cables for corrosion, frayed or broken wires, and defective terminal lugs and battery clamps. If corroded,
clean as required by wiping with a wiping rag. If loose, remove and replace terminal lugs as required using
electrical repair kit. If defect exists, use electrical repair kit and replace defective terminal lug, battery clamp,
and/or wiring harness.
2.
Inspect for damage to protective covering and missing or unreadable wire markers. If defect exists, replace
markers as required.
3.
Inspect jumper wires for frayed or broken wires and loose terminal lugs. If defect exists, replace defective
terminal lugs using electrical repair kit or replace entire jumper wire assembly.
INSTALLATION
1.
Insert cable (37) and grommet (38) into electrical box (17).
2.
Attach cable (37) with capscrew (36), lockwasher (35), and nut (34).
3.
Insert grommet (33) and cable (23) into electrical box (17).
4.
Reconnect jumper (32) and cable (23) to stud #4 of solenoid (31) and secure with lockwasher (30) and nut (29).
5.
Reconnect wire to bolt (27) and insert bolt (27) through side of electrical box (17).
6.
Attach cables (24 and 28) to bolt (27) and secure with lockwasher (26) and nut (25).
7.
Install two cable clamps (22) to cables (23 and 24) and secure with screw (21), washer (20), lockwasher (19), and
nut (18).
8.
Install cover (16) to electrical box (17).
4-523
