TM 9-2330-383-14&P
c. Check for shorts to ground between wiring harness connector pins J1-C, J, E,
F, A, B and pin D (ground). There should be an open circuit between the
connector pins. If there is continuity between any connector pin as
specified, that circuit is grounded and the wiring harness must be repaired
or replaced.
e. Check for grounds from each light lead wire and the chassis (ground). There
should be an open circuit between each lead wire and the chassis. If there is
continuity on any lead wire, the wire is grounded and must be repaired or the
light replaced.
4-15