TM 9-2330-383-14&P
REPAIR
a. Install drum on lathe and turn drum, as required, until a smooth finish can
be obtained. If, after a series of attempts, a smooth finish cannot be
obtained, discard drum.
b. If a smooth finish is obtained, remeasure inside diameter. If inside diameter
exceeds 16.620 inches, discard drum and replace.
c. If a smooth finish is obtained and maximum inside diameter is less than
16.620 inches, drum is repaired.
END OF TASK
Section III.
PREPARATION FOR STORAGE OR SHIPMENT
5-8. PREPARATION FOR STORAGE
a. Open drain cocks on all three air tanks on the trailer (para. 4-22).
b. Cage rear brake air chambers (para. 3-6).
c. Perform complete lubrication (para. 3-2).
d. Reduce tire pressure to 20 psi (cold).
END OF TASK
5-9. PREPARATION FOR SHIPMENT
a. Open drain cocks on all three air tanks on the trailer (para. 4-22).
b. Cage rear brake air chambers (para. 3-6).
c. Perform complete lubrication (para. 3-2).
d. Reduce tire pressure to 20 psi (cold).
END OF TASK
