TM 9-2330-384-14&P
4-52. LANDING GEAR REPLACEMENT.
THIS TASK COVERS
Installation
a.
Removal
c.
Cleaning
b.
INITIAL SETUP
Equipment Conditions:
Materials/Parts:
Ref Condition
Two retaining rings
Nine locknuts
Dry cleaning solvent
(Item 10,
and coupled to tractor.
(Item 24, Appendix E)
Mylar tape
--
Landing gear raised.
General Safety Instructions:
Tools:
Landing gear is heavy and awkward to han-
Tool kit, general mechanic's
dle. Use caution, provide adequate sup-
Torque multiplier
port, and use assistance during removal
Torque wrench
and installation.
Dry cleaning solvent is flammable and must
Personnel Required: Two
not be used near open flame. Use only in a
well-ventilated area.
a.
REMOVAL
NOTE
Removal of curbside landing gear leg (11) is described. Roadside land-
ing gear leg is removed the same, except that it has no handcrank (9).
If removing sand shoe, perform step 7.
(1) Unstow handcrank (9) from clip
(10) on landing gear leg (11). Re-
move locknut (5), two washers
(6), and screw (7). Remove hand-
crank. Discard locknut.
4-161