TM 9-2330-384-14&P
4-57. EQUALIZER AND EQUALIZER BUSHING REPLACEMENT (Con't).
(5) Work bushings (7 and 8) loose and remove. Discard bushings.
(6) Remove equalizer (2), if damaged.
b. INSTALLATION
(1)
Lightly coat two new bushings (7 and 8) with a mixture of 50% water and 50% detergent.
(2)
If removed, position equalizer (2) at frame hanger (3).
(3)
Alining equalizer (2) and frame hanger (3), install bushing (8) with a rawhide hammer.
NOTE
Bolt (5) at equalizer (2) must be installed with locknut (9) to outside.
(4)
Assemble thin washer (6) and bushing (7) on bolt (5). Install bolt, thick washer (4), and new
locknut (9). DO NOT fully tighten locknut.
(5)
If' removed, install new rebound bolt (1) and new locknut (10). Torque locknut to 50 lb.-ft.
(68 Nm).
(6) Torque locknut (9) to 350 lb.-ft. (475 Nm).
(7)
If removed, install front or rear spring (11) (see paragraph 4-56).
(8)
Lower frame. Remove jackstand and lower axle.
4-180
