TM 9-2330-384-14&P
Section XV.
PAINTING AND IDENTIFICATION MARKING
Paragraph
Page
Title
Number
Number
Painting and Identification Marking . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-85. PAINTING AND IDENTIFICATION MARKING.
a. PAINTING. Refer to TM 43-0139 for instructions on painting the M1062 7500 Gallon Fuel
Tank Semitrailer.
b. STENCIL MARKINGS.
(1)
If stencil markings are not legible, stencil must be repainted. Paint numerals or letters
in simple block type, using black paint.
WARNING
Dry cleaning solvent P-D-680 is toxic and flammable. Always wear protective
goggles, face shield, and gloves, and use only in a well-ventilated area.
Avoid contact with skin, eyes, and clothes and DO NOT breathe vapors. DO
NOT use near open flame or excessive heat. The solvent's flash point is
100F-138F (38C-59C). If you become dizzy while using cleaning sol-
vent, immediately get fresh air and medical help. If solvent contacts eyes,
immediately wash your eyes with water and get medical aid.
(2)
Before applying paint, clean all surfaces to be stenciled with dry cleaning solvent
WARNING
Avoid excessive inhalation of vapors when stenciling. All stenciling pro-
l
cedures must be performed in a well-ventilated area. A fire extinguisher
must be on hand. Failure to follow this warning may result in injury to
personnel.
Personnel must wear protective face masks if spraying paint. If face
l
masks are not available, apply paint with brush only. Personnel must stay
clear of work area where spray painting is taking place. Failure to follow
this warning may result in injury to personnel.
(3)
Apply paint to stencil with dabbing motion.
(4)
Allow paint to dry for 24 hours.
4-284