TM 9-2350-222-10-2
DRIVE THE VEHICLE (START ENGINE) - Continued
14. Operate accelerator pedal (W) until tachometer (Z) indicates
1000 to 1200 rpm. Pull up on accelerator lock handle (AA) to
lock accelerator pedal.
15. Allow engine to warm up at 1000 to 1200 rpm for at least three
minutes. While engine is warming up, continue with step 16.
CAUTION
If following indicators show other than
conditions listed in step 16, damage to engine
may occur. Push up and hold ENGINE FUEL
SHUTOFF switch (Y) until engine stops and
notify organizational maintenance.
NOTE
For BATT GEN INDICATOR problems, see
troubleshooting (page 3-20).
16. Check that indicators are as follows:
a. BATT GEN INDICATOR (AB) needle is in green area.
b. ENGINE oil TEMP (AC) needle is in green area (between
1200 and 2250).
c. ENGINE oil PRESS (AD) needle is in green area (between
40 psi and 70 psi).
d. TRANSMISSION oil TEMP (AE) needle is in green area
(between 1600 and 2800).
e. TRANSMISSION oil PRESS (AF) needle is in green area
(between 8 psi and 40 psi).
f. DUST DETECTOR WARNING LIGHT (AG) (if equipped)
OFF.
2-211