C6, TM 9-2350-230-12
ALIGNMENT PROCEDURE
1. REMOVE SPENT BRASS CHUTE EXTENSION
(FIG. 3-7).
2. REMOVE 2 SCREWS AND WASHERS, REMOVE
BRACKET WITH SPENT BRASS CHUTE AND BAG.
3. PULL REARWARD ON DISCONNECTOR RING,
ROTATE RECEIVER CLOCKWISE AND REMOVE.
4. LOOSEN 2 MOUNTING SCREWS SLIGHTLY.
5. LOOK THROUGH BARREL AND LOOSEN UPPER
OR LOWER ADJUSTING SCREW TO ALIGN
BARREL IN ELEVATION WITH DISTANT AIMING
POINT.
TIGHTEN OPPOSITE ADJUSTING
SCREW AND 2 MOUNTING SCREWS (ITEM 4).
6. LOOSEN 2 MOUNTING SCREWS SLIGHTLY.
7. LOOK THROUGH BARREL AND LOOSEN LEFT OR
RIGHT ADJUSTING SCREW TO ALIGN BARREL IN
AZIMUTH WITH DISTANT AIMING POINT.
TIGHTEN OPPOSITE ADJUSTING SCREW AND 2
MOUNTING SCREWS (ITEM 6).
8. PULL REARWARD ON DISCONNECTOR RING
(ITEM
3),
ROTATE
RECEIVER
COUNTERCLOCKWISE AND INSTALL RECEIVER.
Figure 2-24. Aligning 7.62 mm machine gun
2-40
