C6, TM 9-2350-230-12
TABLE 5-9. DISASSEMBLY/ASSEMBLY - 7.62MM MACHINE GUN - Continued
DISASSY
ASSY
PROCEDURE
FIG/ITEM
STEP
STEP
NOTE. Use dummy cartridges to check functioning of machine gun.
2
12
Pull right side disconnector pull ring rearward, rotate
jacket assembly with bearing group counterclockwise
until mounting block is free of receiver assembly. Push
jacket assembly with bearing group forward and remove
from receiver assembly.
NOTE. When installing, position jacket assembly mount-
ing block, hold on one disconnector pull ring, pull out on
opposite disconnector pull ring, rotate the group into
position, release ring.
3
11
To remove, pull barrel assembly from jacket assembly
with bearing group. When installing, position barrel
assembly into rear of jacket assembly with bearing
until slot in barrel is alined with barrel locator. Push
barrel forward until stopped by locator.
WARNING: Turn barrel assembly to make certain
barrel locator enters barrel slot.
4-5
9-10
Remove cover assembly from receiver assembly. When
installing position cover assembly on cover latch rod
assemblies, then press down on cover until it locks
in position.
NOTE. Cover latch rod assemblies in locked (forward)
position. Locks are released automatically by cover
assembly when installed.
6
8
Lift up and remove feed tray group. When installing position
feed tray group with cartridge stop on the right of the
receiver.
NOTE. Feed tray group may be removed or installed with
cover assembly.
WARNING: Make certain that the barrel extension assembly
is in forward position to prevent injury to personnel.
7
7
Push guide rod assemblies forward, rotate 1/4 turn counter-
clockwise to unlock, then remove rod assemblies and
compression helical springs from holes in back plate
assembly with solenoid. To install, position springs on
guide rods, insert in holes in back plate, and into holes
in rear of barrel extension, compress and rotate clock-
wise until secure.
8
6
Slide back plate assembly with solenoid upward and remove
from receiver assembly. To install, aline grooves on
back plate with flanges on receiver assembly and push
downward.
5-25