C10, TM 9-2350-230-12
Section 9-4. TRACKS AND SUSPENSION
c. Periodic lubrication will be in accordance with LO
9-12. General
9-2350-230-12. Assembly/installation instructions will
specify additional lubrication procedures required in
conjunction with assembly/installation.
a. This section contains organizational maintenance
instructions for the vehicle suspension system as shown
d.
Whenever plugs are used in suspension
in figures 9-59, 9-60, and table 9-10
lubrication system, use only hardened hex recessed
head plugs, FSN 4730-278-3462. The correct plugs are
b. All two-piece bearings (cup and cone)are supplied
identified by embossed or raised markings radiation from
only in matched sets.
corners of hex recess.
TABLE 9-10. TRACKS AND SUSPENSION
FIGURE REFERENCE
REMOVE
ASSEMBLY OR COMPONENT
INSTALL
REPLACE
REPAIR
Road Wheels
Torsion Bar and Road Wheel Arm Assembly
Torsion Bar Anchors
Road Wheel Spindle
Position No. 2 and No. 3 Road Wheel Arm
Housing and Shaft Assembly
Position No. 1, 4, and 5 Road Wheel Arm
Housing and Shaft Assembly
Track Hydraulic Adjuster and Bracket
Track Idler Wheels
Idler Hub Assembly
Idler Housing and Spindle Assembly
Sprocket Drive Shaft
Sprocket and Sprocket Carrier Wheels
Sprocket Hub and Support
Shock Absorber and Mounting Bracket
Suspension System Seal Installation Specifications
Suspension System Special Tools (1 of 4)
Suspension System Special Tools (1. 1 of 4)
Suspension System Special Tools (2 of 4)
Suspension System Special Tools (3 of 4)
Suspension System Special Tools (4 of 4)
Track Shoe
Replacing Damaged Track Shoe
9-66