C 14, TM 9-2350-230-12
Table 10-3. Electric Drive Control System Test Procedure
--Continued
FINAL GAIN AND BALANCING PROCEDURES
NOTE
Final balancing of the system for both stabilized and nonstablized modes should be performed with
engine running. Vibration caused by engine or 'voltage ripple caused by the generating system will in
no way affect turret test set. However, following use of test set and/or when general troubleshooting
an electrical circuit, running of the engine is not recommended.
1. Operate the electric drive control system.
NOTE
The electric drive system may be operated with the test set connected providing:
a. Test set selector is on "0".
b. Test set switch is in "OFF" position.
2. The system gain is properly adjusted when weapon or turret does not oscillate when palm switch is depressed.
a. If oscillation occurs in non-stabilized mode, Turn ELEV and TRAV gain pots in amplifier integrator clockwise
until oscillation stops.
10-8.11