TM 9-2350-277-10
INSTALL/REMOVE AN/VVS-2(V)1A DRIVER'S NIGHT VISION (ALL EXCEPT M58) -- Continued
2.
Loosen two viewer handles on viewer adapter mount and slide rear cleat by pulling back handle. Tilt plug assembly to
remove from viewer adapter mount in hatch.
3.
Stow plug in Basic Issue Items bag. Stow bag in a suitable place in the vehicle.
4.
Install strap assembly, stowage cover, and entrance window cover on stowage bracket.
REAR
CLEAT
REAR
FORWARD
CLEAT
CLEATS
VIEWER
HANDLE
HANDLES
5.
Check to see that driver's night vision is in center detent position so that mount assembly is square with the side of the
entrance window housing. If not, rotate it in its mount until it stops in center detent position.
6.
Hold driver's night vision in an upright position with the window pointing forward and then push entrance window
carefully through viewer adapter mount in hatch.
0034 00-2
Change 3