TM 9-2590-209-14&P
Figure 4-6. Removal or installation of cutting edge.
Section VI. MAINTENANCE OF PUSHBEAM
4-20.
Description.
The pushbeams are located
CAUTION
between the vehicle and the blade assembly. The ram
Before removing pin, support weight of pushbeam with a
assembly is attached to the pushbeam. Up and down
floor jack or wood block.
motion on the pushbeams causes the blade assembly to
be raised and lowered.
c. Remove screw, lockwasher, lock, and pin
securing pushbeam to mounting bracket (view B).
4-21. Removal (Fig 4-7).
d. Install lifting device to pushbeam.
NOTE
e. Remove two screws, lockwashers, lock and pins
Procedures for both left and right sides are the same.
securing pushbeam to blade assembly, and remove
pushbeam (view C).
a. Lower blade assembly to rest on ground.
b. Remove screw, lockwasher, and lock securing
pin. Remove pin securing ram assembly to pushbeam
(view A).
4-13
