TM 9-2590-209-14&P
b. Installation
NOTE
NOTE
Rod assembly (2) length (3-3/16 inches)
is measured between faces of two
Perform steps 1 and 2 only if removed.
locknuts.
(1) Position guard (4, fig 4-27) to front right
(14) Install rod assembly (2) to arm (3), and
torsion bar housing, and secure with two screws (5) and
secure with nut (1).
lockwashers (6). Secure other side of guard to manifold
with six screws and gasket.
(15) Insert key (21) into shaft (22); install lever
(17, fig 4-23) on shaft (22), and secure with nut (18),
(2) Install housing assembly (1), shaft (2), and
lockwasher (19), and washer (20).
lockwasher (3) into guard (4).
NOTE
(3) Install rod end (10, fig 4-26) and two nuts
(9) to rod (8).
Rod assembly (15) length (5-7/8 inches)
is measured between faces of two
(4) Install link assembly (3) to guard, and
locknuts.
secure with bolt (12).
(16) Install rod assembly (15) to lever (17), and
(5) Adjust rod assembly (8) length for proper
secure with nut (16).
operation.
(17) Install arm (13) to rod assembly (15), and
(6) Install rod assembly (8) to link assembly
secure with nut (14).
(3), and secure with screw (7).
(18) Install shaft (8) to arm (13), insert key (9),
NOTE
and secure with nut (10), lockwasher (11), and washer
(12).
Rod assembly (8) length (2-15/16
inches) is measured between faces of
(19) Install arm (4) to shaft (8); insert key (9),
two locknuts.
and secure with nut (5), lockwasher (6), and washer (7).
(7) Install clevis (6) to control valve located in
NOTE
manifold, and secure with pin (5) and cotter pin (4).
Rod assembly (2) length (3-7/8 inches)
(8) Insert rod assembly (2) through guard.
is measured between faces of two
locknuts.
(9) Install rod assembly (2) to link assembly
(3), and secure with nut (1).
(20) Install rod assembly (2) to arm (4), and
secure with nut (3).
(10) Install bracket (10, fig 4-24) to guard, and
(21) Install rod assembly (2) to bottom of
control lever, and secure with nut (1).
(11) Install rod assembly (12) to bracket (10),
and secure with nut (11).
c. Adjustment.
(12) Install arm (3) on housing assembly with
(1) Move lever control and insure that it shifts
key (8), washer (6), lockwasher (5), and nut (4).
freely from one position to the other. Re-adjust rod
assemblies, if necessary.
(13) Install rod assembly (2) to bracket (10),
and secure with nut (9).
4-55