TM 9-2590-209-14&P
(2) Align gage indicator panel sup port bracket
(9) Disconnect lead assembly between
and hydraulic pump control panel bracket to mounting
connector and bulkhead; remove lead assembly.
(M60A1, M60A1 RISE, and M60A3 only).
(10) Disconnect lead assembly between
magnetic clutch and connector; remove lead assembly.
(3) Connect wiring harness cable connector to
b. Repair.
receptacle on rear of gage indicator panel (M60A1,
M60A1 RISE and M60A3 only).
(1) Examine the lead assembly for damaged
(4) Install hydraulic pump circuit breaker (para
connector, conductors, or insulation.
(2) Replace defective connector parts (Fig 4-
(5) Install HYDRAULIC PUMP indicator lamp
29).
(3) Repair damaged leads by wrapping base
(6) Install
HYDRAULIC
PUMP
electrical
conductors with waterproof insulating tape, or install a
jumper wire as a substitute. Refer to wiring diagram for
4-94.
Wiring Harness.
(1) Connect lead assembly between magnetic
clutch and connector.
(1) Place
MASTER
BATTERY, switch in
OFF position.
(2) Connect
lead
assembly
between
connector and bulkhead.
(2) Open turret platform access door, and
disconnect battery cables. See TM 9-2350-215-20 (M60,
(3) Install
lead
assembly
to
bulkhead
M60A1), TM 9-2350257-20-1 (M60A1 RISE), or TM 9-
connector.
2350-25320-1 (M60A3).
(4) Install lead assembly (circuit number
(3) Disconnect electrical lead assembly
415E) to hull floor.
connectors from circuit breaker and connector assembly.
(5) Install wiring harness clamps and cover,
(4) Disconnect
wiring
harness
from
and secure with bolts.
HYDRAULIC PUMP electrical switch and circuit breaker.
(6) Connect wiring harness to HYDRAULIC
(5) Disconnect
lead
assembly
from
PUMP electrical switch and indicator lamp assembly.
HYDRAULIC PUMP electrical switch and indicator lamp
assembly.
(7) Install
lead
assembly
between
HYDRUALIC PUMP electrical switch and circuit breaker.
(6) Remove bolts securing wiring harness
clamps and cover.
(8) Install lead assembly between circuit
breaker and connector assembly.
(7) Remove lead assembly (circuit number
415E) from hull floor.
(9) Reconnect battery cables and close turret
access doors TM 9-2350-215-20 (M60, M60A1), TM 9-
(8) Remove lead assembly.
2350-257-20-1 (M60A1 RISE), or TM 9-2350-253-20-1
(M60A3).
4-62